Drive Test

• On road drive test
• The practical drive test is conducted after you have passed your Hazard perception test. During the test, you will have your Melbourne Driving School driving Instructor accompany you, whilst the Vic roads tester sits in the back Seat. You will drive for between 30 to 50 minutes around a pre determined drive test route near the Vicroads office.

The driving test is split into three Sections:

• Pre-drive check
• Residential Driving and Low Speed Manouever
• Busy multiple lane roads and more complex situations
  

To apply for your licence in Victoria you must be at least 18 years of age and have held your learner permit for a minimum period of time.

There are three steps involved in passing your licence test. You must pass:

• An eyesight test
• A hazard perception test
• A practical driving test

It is recommended that while you are on your learner permit you complete at least 120 hours of driving in all conditions to prepare you for your test and to be a safer driver on our roads.

If you pass your drive test, you will be issued with a Probationary drivers licence, which is valid for three years. During this time you will have certain restrictions imposed on you.

Once you have held your probationary licence for the appropriate amount of time, you will progress to a full licence without the need to do any further tests  

What will I be assessed on?

During your driving test, your testing officer will give you simple, clear instructions such as “At the next street, turn right.” If you are unsure of an instruction, you may ask for it to be repeated.’

Your driving test will be marked as follows:

• YES when you do something correctly.
• NO when you do not do something correctly.
• N/A if road or traffic conditions mean you cannot perform the expected behaviour.

Your driving skills will be assessed against a performance checklist for which you must get a YES for at least 80% to pass the test and obtain your licence. Critical errors and Immediate terminations play a major role , and have more impact than percentage or points lost due to minor errors. Your Melbourne Driving School Instructor can  explain more details when taking your driving lessons.

The performance list is as follows:

You must know where these controls are and how to use them:

• Indicators and brake lights*
• Wiper/washer control(s)*
• Horn*
• Headlights – high/low beam*
• Hazard lights*
• Seatbelt*
• Demister
• Handbrake

* If any of these controls are not in proper working order, the test cannot proceed.

You must be able to turn on the engine.

During the drive, your testing officer will check that you do the following:

You must check the mirror immediately before signalling and before braking.

You must signal long enough to give sufficient warning to other drivers and pedestrians before turning, and for at least 5 seconds if merging into traffic or changing lanes. At roundabouts, you must keep signalling whilst driving in the roundabout. You must cancel your signal immediately after turning or diverging.

Before merging into traffic or changing lanes, you must do a head check by turning your head and looking through the appropriate side window to check for other road users in your blind spots. You must maintain reasonable progress and ensure a safe gap in the traffic.

You must brake smoothly using brakes only or brakes and gears when slowing down or stopping.

You must stop the car within 2 metres of the stop line at a stop sign. You must not stop with the front wheels on or in front of the stop line. If there is no stop line, you must stop as close as practical to, but before the stop sign or intersection.

At intersections, you must slow down, look in the correct direction(s) and react correctly to other vehicles and pedestrians.

When turning, you must drive in the correct lane or position on the road and follow all road markings and traffic lane arrows.

You must travel at a suitable speed for the conditions but not above the speed limit.

Your car must travel entirely within the lane markings of the correct lane or in the correct lane of traffic.

You must control the vehicle correctly using steering, gears and clutch (if fitted), brakes, accelerator and handbrake.

You must keep an acceptable safety margin (distance) when following other vehicles.

3. Low Speed Manoeuvring

This aspect of the assessment will test your control of the car at low speed including in reverse.

You should not turn the steering wheel while the car is stationary (dry steering).

You will be asked to do one of these low speed manoeuvres during your driving assessment:

You will be required to pull up next to a legally parked vehicle and asked to reverse into the space behind the vehicle.

• Look in the direction of travel before and during reversing
• Position your car parallel to the kerb within 300mm and be between 1 and 2 metres from the car in front
• Not reverse back further than 7 metres from the vehicle in front
• Use no more than 4 and no less than 2 movements to enter the space and no more than 4 to leave it
• Signal and do a head check before leaving the space

Three Point Turn

You will be asked to make a three point turn (turn your car around) on a road which is not as wide as your car’s turning circle.

You should be able to complete this manoeuvre in three movements:

You must:

• Put on your left signal before stopping at the kerb
• Position your car parallel to and within 300mm of the kerb before starting the turn
• Put on your right signal before leaving the kerb
• Look in both directions before commencing the turn
• Proceed across the road to the opposite kerb
• Look in both directions along the road before reversing
• Look in the direction of travel before and during reversing
• After reversing, look in both directions before moving off

For you to pass the low speed manoeuvre aspect, you should not

• Take longer than 2 minutes to complete the manoeuvre
• Mount the kerb
• Finish positioning your car with the front and/or left wheels more than 1 metre from the kerb
• Take more than 5 movements to complete the three point turn
• Reverse any part of your car over the centre of the road during the point to point reverse or the reverse parallel park

What are immediate terminations?

You will be failed immediately if you do anything deemed illegal or unsafe. For example:

Not stopping at a:

• Red traffic control signal
• Stop sign and/or stop line
• School crossing with the flags or signs displayed when any pedestrian is on the crossing

Position after stopping:

If you stop at a location that placed another road user in a dangerous situation.

Colliding with:

• Another vehicle
• A pedestrian
• An object such as rubbish bin or pole placed on or near the road

Dangerous actions such as:

• Requiring emergency braking or swerving by another driver, or dodging by a pedestrian to prevent collision
• Requiring the instructor or testing officer to come to your aid in controlling the car
• Driving any wheel over the kerb or onto the footpath
• Committing any driving fault which causes immediate danger to any person or property
• Lack of control to the point where the testing officer believes continuing the assessment would be dangerous
• Improper action causing collision of other vehicles in the immediate vicinity

Speed Limits

Driving over the speed limit for more than 5 consecutive seconds from when speeding is verified.

Slow Driving

Driving too slowly without reason continuously for more than 10km/h under the speed limit. On completion of the test, you will be given a copy of your results. The “Improvement Needed” section will identify your strengths and your weaknesses. This feedback will provide you with the opportunity to further improve your driving skills by concentrating your efforts on those weaker areas.

Information is drawn from a brochure entitled “What you need to know about your licence assessment”, produced by VicRoads. If you require further information, please visit their website at www.vicroads.vic.gov.au